HPUX man pages für Kapitel 3i

gpio_set_ctl - set control lines on GPIO card

hpib_abort() - stop activity on specified HP-IB bus

hpib_address_ctl() - set the HP-IB bus address for an interface

hpib_atn_ctl() - control the Attention line on HP-IB

hpib_bus_status() - return status of HP-IB interface

hpib_card_ppoll_resp() - control response to parallel poll on HP-IB

hpib_eoi_ctl() - control EOI mode for HP-IB file

hpib_io() - perform I/O with an HP-IB channel from buffers

hpib_parity_ctl() - enable/disable odd parity on ATN commands

hpib_pass_ctl() - change active controllers on HP-IB

hpib_ppoll() - conduct parallel poll on HP-IB bus

hpib_ppoll_resp_ctl() - define interface parallel poll response

hpib_ren_ctl() - control the Remote Enable line on HP-IB

hpib_rqst_srvce() - allow interface to enable SRQ line on HP-IB

hpib_send_cmnd() - send command bytes over HP-IB

hpib_spoll() - conduct a serial poll on HP-IB bus

hpib_status_wait() - wait until the requested status condition becomes true

hpib_wait_on_ppoll() - wait until a particular parallel poll value occurs

io_burst() - perform low-overhead I/O on an HP-IB/GPIO channel

io_dma_ctl() - control DMA allocation for an interface

io_eol_ctl() - set up read termination character on special file

io_get_term_reason() - determine how last read terminated

io_interrupt_ctl() - enable/disable interrupts for the associated eid

io_lock - lock and unlock an interface

io_on_interrupt() - device interrupt (fault) control

io_reset() - reset an I/O interface

io_speed_ctl() - inform system of required transfer speed

io_timeout_ctl() - establish a time limit for I/O operations

io_unlock - lock and unlock an interface

io_width_ctl - set width of data path