HPUX man pages für Kapitel 7 HPUX man pages für Kapitel 7
blmode - terminal block mode interface
cent - Centronics-compatible interface REMARKS This manual entry applies only to peripherals connected to the cent interfaces found on Series 300, 400, and 700 systems.
clone - opens a major and minor device pair on a STREAMS driver
console - system console interface
ct - Command-Set 80 (CS/80) cartridge tape access
ddfa - HP DTC Device File Access software
diag0 - diagnostic interface to I/O subsystem
disk - direct disk access
floppy - direct flexible or ``floppy'' disk access
framebuf - information for raster frame-buffer devices
gpio - general-purpose I/O interface
graphics - information for CRT graphics devices Remarks: This information is valid for Series 300/400 only.
groff_char - groff character names
groff_mm - groff mm macros
groff_ms - groff ms macros
hil - HP-HIL device driver
hilkbd - HP-HIL mapped keyboard driver
hpib - Hewlett-Packard Interface Bus driver
intro - introduction to special files
iomap - physical address mapping
kmem - main memory
lan - network I/O card access information
lp - line printer Remarks: This manual entry applies only to a certain group of printers. For Series 800 systems, it applies to printers controlled by the device drivers lpr0, lpr1, and lpr2. For Series 300/400 systems, it applies to printers controlled by device drivers printer and ciper. It does not apply to any printers on Series 700 systems.
me - troff macros for formatting papers
mem - main memory
modem - asynchronous serial modem line control
mt - magnetic tape interface and controls
NFS - network file system
null - null file
ps2mouse - PS/2 Keyboard/Mouse device driver
pty - pseudo terminal driver
routing - system support for local network packet routing
sad - STREAMS Administrative Driver
scsi - Small Computer System Interface device drivers
scsi_changer - SCSI media changer device driver
scsi_ctl - SCSI device control device driver
scsi_disk - SCSI direct access (disk) device driver
scsi_tape - SCSI sequential access (tape) device driver
socket - Interprocess communications
socketx25 - Interprocess communications via AF_CCITT sockets
streamio - STREAMS ioctl commands
strlog - STREAMS log driver
stty - terminal interface for Version 6/PWB compatibility REMARKS These facilities are included to aid in conversion of old programs, and should not be used in new code. Use the interface described in termio(7). Note that these conversions do not work for programs ported from UNIX Time-Sharing System, Seventh Edition (Version 7), because some V7 flags are defined differently.
sttyV6 : stty - terminal interface for Version 6/PWB compatibility REMARKS These facilities are included to aid in conversion of old programs, and should not be used in new code. Use the interface described in termio(7). Note that these conversions do not work for programs ported from UNIX Time-Sharing System, Seventh Edition (Version 7), because some V7 flags are defined differently.
sttyv6 : stty - terminal interface for Version 6/PWB compatibility REMARKS These facilities are included to aid in conversion of old programs, and should not be used in new code. Use the interface described in termio(7). Note that these conversions do not work for programs ported from UNIX Time-Sharing System, Seventh Edition (Version 7), because some V7 flags are defined differently.
termios - general terminal interface
termios - general terminal interface
termiox - extended general terminal interface
timod - STREAMS module for converting ioctl() calls into Transport Interface messages
tirdwr - STREAMS module for reads and writes by Transport Interface users
tty - controlling terminal interface
vt200 - Belegung der deutschen Tastatur am vt200/vt220 Terminal